How to Burn a Voluspa 5 Wick Hearth Candle Evenly
By Luxury Candles | High End Candles | Candle Delirium | Published: 2026-11-04
Category: Ohjeet
A step-by-step routine for the Voluspa Baltic Amber 5 Wick Hearth Candle: wick trimming, full melt pools, safe burn sessions, and when to stop.
Quick answer
Trim all five wicks to about 1/4 inch before every burn, then let the candle burn long enough for the entire wax surface to melt edge to edge. For the Voluspa Baltic Amber 5 Wick Hearth Candle, that usually means a first session of roughly two to three hours, and never longer than four hours at a time.
Why five wicks change the burn routine
A single-wick candle gives you one flame to manage. A five-wick candle gives you five separate heat sources, so uneven trimming or a short first burn can leave wax stranded along the glass while the center burns down. The wider the vessel, the more important it is to let the whole surface liquefy before you extinguish it.
The Voluspa Baltic Amber 5 Wick Hearth Candle is hand-poured into a 123 oz embossed glass vessel with a coconut wax blend. That large wax volume holds heat longer than a small jar, so the cooldown between sessions matters as much as the burn itself.
The trade-off: longer burns versus a cleaner burn
It is tempting to light a large hearth candle for an entire evening. But sessions beyond about four hours can overheat the glass and soften the wax too much, which makes the wicks lean and the next burn less even. Shorter, repeated sessions with full melt pools give you a cleaner result than one marathon burn.
If you want a strong scent throw quickly, resist the urge to light only two or three of the five wicks. Partial lighting creates a lopsided melt pool and can tunnel the unused side.
Step-by-step: burning your 5 wick hearth candle
- Trim all five wicks before every light: Use a wick trimmer or sharp scissors to cut each wick to about 1/4 inch. Check every wick, including the ones near the glass edge. Common mistake: trimming only the center wick and leaving the outer wicks long, which causes a hot, uneven burn. Keep the trimmer next to the candle so trimming becomes automatic.
- Clear the wax surface of debris: Remove any loose wick trimmings, matches, or dust from the wax before lighting. Common mistake: letting trimmings fall into the melt pool, where they can smoke or clog the wick.
- Light all five wicks at once: Use a long lighter or a match to light each wick evenly. Do not light only some of the wicks to control scent strength. Common mistake: lighting two or three wicks and expecting the candle to burn evenly later. If you want less scent, burn for a shorter session rather than fewer wicks.
- Let the first burn reach a full melt pool: Allow the candle to burn until the melted wax reaches the edge of the glass on all sides. For a 123 oz five-wick candle, expect roughly two to three hours. Common mistake: extinguishing as soon as the center melts, which starts tunneling. Set a timer so you do not stop short of the edge.
- Cap each session at about four hours: Extinguish the candle after roughly four hours, or sooner if the glass feels very hot. Let the wax cool and solidify completely before relighting. Common mistake: relighting while the wax is still soft, which shifts the wicks. A fully cooled candle burns more predictably than a warm one.
- Extinguish without smoking: Use a snuffer or gently dip the wicks into the melted wax and straighten them. Avoid blowing hard across five flames. Common mistake: blowing out the candle and leaving a plume of soot on the glass.
- Know when to stop: Retire the candle when about 1/2 inch of wax remains at the bottom, or when the wicks no longer stay lit. Common mistake: burning to the bare glass, which can overheat the vessel. Mark the stop point on your calendar if you burn daily.
Product facts that affect your routine
- Voluspa - Baltic Amber 5 Wick Hearth Candle: The Voluspa Baltic Amber 5 Wick Hearth Candle is a 123 oz coconut wax blend in an embossed glass vessel with five wicks. The large wax volume and five flame points mean you need a full-surface melt pool and consistent trimming across all five wicks, not just the center ones.

Voluspa - Baltic Amber 5 Wick Hearth Candle
